Tus neeg siv phau ntawv

INSTALLATION GUIDE
Step 1
- 1 - - 2 -
- 3 - - 4 -
Unscrew the fixed nut completely. Let the ball joint pass
through the fixed nut (the thread must face to the groove).
Step 3
Clean the dashboard with dry cloth.
Step 5
Let it sit for at least 24 hours before using to achieve
the strongest adhesion.
Step 4
Put the magnetic mount on the dash and firmly press
it. Hold in place for about 30 seconds.
Step 6
Once the mount is secured in place, remove the protective
film and set the Metal Plate.
You may place the metal plate as following shows.
Installation between the case and device
Removal Paper
Metal Plate
Scratch Protective Film
Opition 1
Installation on the back of device
Opition 2
Installation on the back of the case
Opition 3
1 2
Step 2
Push the ball joint firmly into the groove on the back of the car
mount, then tighten the fixed nut.
Magnetic Car Mount
On The Dashboard
MT01
YOUR BEST DRIVE PARTNER
User Manual
Dear Customer
please do not hesitate to
contact us at anytime
If you have any question
we are always here if you need!
ATTENTION!!
- 5 -
- 6 -
Use a thin plastic card
to carefully lift the
dashboard pad from
the mounting surface.
Slowly lift up and
remove it.（Remember
not too hard and
move it slowly）
Tips 2
Remove Dashboard Disk Pad
Tips 1
Viscosity of VHB Sticky Tape
Time of Viscosity
①Cleaning the flat surfaces to ensure that there is no
dust or oil.
②Do not leave fingerprints on the 3M sticky tape.
③When applying, please make sure that the
temperature of the flat surface and the sticky gel
should be above 68℉, or you may soften the 3M VHB
tape under heating air before installation.
④Press for 8 to10 seconds after pasting.
⑤ Recommended to use after 24 hours of pasting.
⑥Never uses the adhesion promoter on the metal
surface.
For better pasting, please kindly note:
3M