User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
８
Warning
When the device input is getting through 42+ Vp-p (30Vrms), or on circuit of 4800+VA, to avoid any
potential short circuit or electric shock -
i. DO use only probes and adapter from original device accessories, or manufacturer’s recommended
ones.
ii. Before working the device, DO check probes and accessories carefully to see whether any mechanical
damages exists, making sure probes and accessories in normal status.
iii. When device in non-working condition, to remove probes and accessories firstly, then put them in
certain places.
iv. When working the device in CAT II environment,
DO NOT get the 40+ V input voltage from earth surface through any non-isolated input;
DO NOT get the 40+ V input voltage of dropout voltage through any non-isolated input
v. DO NOT introduce input voltage larger than rated voltage, especially when probe attenuation set in 1:1,
since the voltage from probe tip will go through to the device itself.
vi. NO NOT contact the exposed part of metal BNC terminal directly by hand or any other body part.
vii. DO NOT insert any metal object into connectors.
- Note -
i). The rated voltage mentioned in point v. is the fixed value of working voltage, matching VACrms / 50 - 60Hz under AC sine
wave application, and VDC under DC sine wave application;
ii). CAT II indicates local level for electrical appliance and portable device.