User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
７
To avoid body injury, and to avoid device damage, its accessory or communicated facility damage, before
working the device, Lilliput strongly recommend to read the following safety information.
Warning
To avoid any potential short circuit or electric shock, DO use original local standard, or manufacturer’s
recommended power adapter.
Warning
The channels of the device is non-isolated electrically. When working the device, to avoid short circuit, the
ground of two probes are NOT allowed to connect to 2 different non-isolated DC level.
The illustration of the device’s built-in ground wire connection -
When the device communicated with PC via USB communication interface (with PC powered by AC
power source), the illustration of the ground wire connection -
It is NOT allowed to measure AC power when the device been powered by AC power source through the
adapter, or when the device powered by PC through USB connection cable (via USB communication
interface of PC, with PC powered by AC power source).