User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
５８
Appendix B. Device Maintenance
Storage
To avoid any possible damage to the device, and probe, keep these items FAR AWAY from sprays,
liquids, or solvents.
Surface Cleaning
As per the operation condition requirements, DO check the device and probe surface from time to
time.
When cleaning the device / probe surface, please follow up with operation steps as follows -
i. Before the surface cleaning, making sure the device been powered off, without any
accessory / outer facility connected; making sure probe not working with device / outer facility.
ii. Use non-electrostatic soft cloth to remove the surface dust.
iii. For further surface cleaning, a wet-but-no-water-dripping soft cloth could be used,
with soft detergent also works.
Note: To avoid permanent damage to the surface of device and probe, DO NOT introduce any corrosive chemical
cleaner / detergent.
Warning:
After device surface cleaning, before working the device for next time, please
confirm that the device surface in a relative dry condition, so as to avoid any
short circuit risk, or possible body injury caused by electric conduction from the wet
surface.
10 / 2019 ISSUE, in V1.0.0