User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
５５
Measurement
Cursor
Measurement
△V and △T between Cursor 1 and Cursor 2
Automatic
Measurement
Vpp, Vmax, Vmin, Vtop, Vbase, Vamp, Vavg, Vrms, Overshoot,
Preshoot, Frequency, Period, Rise Time, Fall Time,
Delay A→B , Delay A→B , +Width, -Width, +Duty, -Duty
Lissajous Figure
Bandwidth
full bandwidth
Phase Difference
±3 degrees
Communication
Interface
USB device (type-C), USB host (Wi-Fi extension supported), LAN
Wi-Fi module available in option
Frequency
Counter
supported
Trigger
Trigger Level
Range
Internal
±5 divisions from the screen center
Trigger Level
Accuracy (typical)
Internal
±0.3 division
Trigger
Displacement
on the basis of record length and time base
Trigger Hold-off
Range
100ns - 10s
Edge Trigger
Slope
rising, falling
Pulse Trigger
Trigger Condition
positive pulse: >, <, =
negative pulse: >, <, =
Pulse Width Range
30ns - 10s
Video Trigger
Modulation
supported standard: NTSC, PAL and SECAM broadcast
systems
Line Number
Range
NTSC: 1 - 525;
PAL / SECAM: 1 - 625
Slope Trigger
Trigger Condition
positive pulse: >, <, =
negative pulse: >, <, =
Time Setting
30ns - 10s
Function Generator Part -
Standard Waveform
sine, square, ramp and pulse
Frequency Output
5 MHz
Sampling Rate
25 MSa/s
Channel Q'nty
1
Vertical Resolution
10 bits
Output Impedance
50 Ω (typical)