User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
５１
dot-tick “Auto-detect of LAN Instrument”, then “Next”
f. to following window,
dot-tick “Select instrument(s) detected on local subnet”,
to choose “TCPIP0::(the previous IP connection
just added)::inst0::INSTR”, then mouse-click “Finish”.
g. back to PC software, to press TCPIP0::(the previous IP connection just added)::inst0::INSTR to
communicate with PC software,