User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
５０
ii) to add NI network device
a. device powering. To disconnect the USB communication between the device and target PC, with AC
adapter get through power source, then power the device, with indicator lights red for seconds.
b. WiFi communication. To communicate the device with target PC through WiFi hotspot set onto device, as
per correct SSID and Password.
- Note -
Provided not possible to auto-switch between WiFi and LAN connection onto target PC, disable LAN.
Dot-tick “Obtain an IP address automatically” for the IP address onto target PC, or use the same first 3
sections of IP address set as point b. under i) part, say, 192.168.100
c. choose NI Max from Windows Start menu.
d. following page comes,
via “Devices and Interfaces”, then “Network Devices”, enter into “Add Network Device”
e. press to,