User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
４９
to work WiFi with PC software through device station
The target PC should support WiFi communication, and the optional WiFi module should be inserted into USB host
communication interface.
i) to set device’s network via “Network” button under “Utility” option
a. to communicate device with target PC through USB connection cable via suitable USB communication
interface, after the communication successful (please refer to iv. to communicate device with PC under V.
How to Communicate Device with PC), press “Network” button under “Utility” option from function menu.
b. in “Network”, mouse-click “WiFi Setup” to “WiFiSetting” choose “STA” as “Connect Type”, to set “SSID”
and “Password”, “Port” here use 8866 (could be any value, ranging from 0 till 65536).
c. input correct “SSID” and “Password” from WiFi router, here we use one available WiFi router - SSID in
OWONTM, Password in lilliputowon, press “OK” to confirm the setting, after the step, “WiFiSetting” menu
will be off. Re-enter “WiFiSetting” menu, press “Refresh” to update the IP address.