User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
３７
AutoSet
To set function items in certain value automatically, so as to generate more-suitable-for-observing
waveform. Mouse-click , the device capture the signal automatically, and promptly. The involved
function items is as follows -
Trigger
Trigger Type
Edge, or Video, as per the input signal
Trigger Mode
Auto
Trigger Coupling
DC
Trigger Slope
Rise
Trigger Level
mid-point setting
Channel
Turn On / Off Channels
turn on the channel with signal input
Vertical Coupling
DC
Zero Point Position
been adjusted to the proper position
Vertical Scale
been adjusted to the proper division
Horizontal Level
middle
Horizontal Sale
been adjusted to the proper division
Sampling
Run/Stop Status
Run
Acquisition Mode
current
Display
Display Format
YT
Run/Stop
To start or stop sampling on input signals.
Single Trigger
To set trigger mode in “Single”, under this trigger mode, when set condition met, the device will capture
the input signal once, then stop signal capturing.
Keyboard Shortcuts
Ctrl + Enter
AutoSet
F5
Run/Stop
xiii. how to use LAN communication interface
Through LAN communication interface, the device may communicate with PC directly, or via router
connection
the device communicates with PC by direct LAN
i) to check target PC’s network setting
giving an example, here we set IP address in 192.168.1.71