User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
３２
i) check / uncheck measurement type, available in Time and Voltage option, cursor measurement works
for either Time, or Voltage measurement, or both measurement at the same time;
ii) when in Voltage measurement type, the target channel could be chosen from “CH1” and “CH2” option;
time cursor measurement: Check "Time" option, from the vertical direction of main display area, two
lines in light color appears, indicating Cursor 1 and Cursor 2.
When moving mouse pointer through Cursor 1 or Cursor 2, it shapes , drag leftwards, or
rightwards to adjust the measurement range between Cursor 1 and Cursor 2. The cursor measurement
extension window (located at the bottom-left of main display area) tells the current time of Cursor 1 /
Cursor 2, the absolute time difference between Cursor 1 and Cursor 2, and the frequency, as the
illustration goes,
voltage cursor measurement: Check "Voltage" option, from the horizontal direction of main display area,
two lines in light color appears, indicating Cursor 1 and Cursor 2.