User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
３１
8 Bits
indicates the device works in 8-bit vertical resolution from ADC
12 Bits
indicates the device works in 12-bit vertical resolution from ADC
14 Bits
Indicates the device works in 14-bit vertical resolution from ADC
viii. how to set built-in function generator
The built-in function generator of 5MHz frequency output available from the device, with 4 basic waves
output - sine, square, ramp and pulse, through MULTI communication interface.
From Function menu, via , enter into "Function Generator" option.
i) choose preferred wave type from "Type", either Sine, or Square, or Ramp, or Pulse;
ii) input Frequency range, remember to match its unit - Hz / kHz / MHz;
iii) set Offset correctly
Further, Symmetry option comes under Ramp wave Type; and Duty Cycle option available in Pulse wave
Type.
ix. how to use cursor measurement
From Function menu, via , enter into "Mark Cursor" option.