User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
２９
To know more about different sampling mode -
Sampling
indicates normal sampling mode
Peak Detect
this sampling mode always been used to capture interrupting signal noise
Average
this sampling mode is to reduce random / irrelevant signal noise, with set range from 1 to
128 (1≤ the set no. ≤128)
Following illustration is signal output under normal Sampling mode, no interrupting signal noise been
captured,
Following illustration is signal output under Peak Detect mode, the interrupting signal noise been captured
in details,