User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
２２
Note: For first operation, after mouse-clicking , the Home of Function Menu comes,
via to choose "Trigger" option (or mouse-click from right-bottom extension window to
show this option).
The Trigger option here indicate single trigger, it is the one to use one trigger signal to capture data from
two channels, simultaneously, the operation steps -
i). choose “CH1” or “CH2” from “Source”;
ii). next “Mode”, 4 options under “Mode”: edge trigger, video trigger, slope trigger and pulse trigger.
Edge Trigger: when certain level gets through trigger signal input at certain direction, edge trigger
happen