User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
２０
choose the ideal option.
Or through rotating the mouse wheel, to choose the ideal option.
Through zero point position control bar,
to reset zero point position will change the vertical position of the signal, via moving the slider upwards, or
downwards - the farther slider from the center of control bar, the faster the vertical position changes.
Another solution is to drag the zero point pointer upwards or downwards (as item 22 and 21 goes under
VII. Operation Interface of PC Software).
Keyboard Shortcuts
Q
1 division less from Channel 1’s voltage division
A
1 division more from Channel 1’s voltage division
W
1 division less from Channel 2’s voltage division
S
1 division more from Channel 2’s voltage division