User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
１８
iii. following status indicates the working of the device
Auto
automatic trigger mode
Ready
ready for receiving trigger
Trig'd
signal triggered
Scan
slow scan mode
Stop
the device stops acquiring signal data
Error
error occurred
ReSyncing
re-synchronize with the device
AutoSet
in process of auto setting
Keyboard Shortcuts
F5
Run/Stop
Ctrl + Enter
Auto Set
Q
1 division less from Channel 1’s voltage division
A
1 division more from Channel 1’s voltage division
W
1 division less from Channel 2’s voltage division
S
1 division more from Channel 2’s voltage division
←
1 division less from time base
→
1 division more from time base