User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
１６
VI. Operation Interface of PC Software
1.
Status Indicating Area: please refer to “Status Details List”
2.
Main Display Area
3.
Red Pointer: to indicate the horizontal position of one conditioned trigger
4.
Violet Pointer: to indicate the trigger position in the recorded data
5.
Time Range measured by certain cursor measurement
6.
Auto Set: please refer to xii. how to use main action button
7.
Run/Stop: please refer to xii. how to use main action button
8.
Single Trigger: please refer to xii. how to use main action button
9.
Back to Home of Function Menu
10.
Hide the current menu
11.
Voltage Range measured by certain cursor measurement
12.
Red Pointer: the trigger level position of Channel 1;
Yellow Pointer: the trigger level of Channel 2.
Via dragging Red / Yellow Pointer upwards or downwards, to adjust the trigger level position of Channel 1 / 2.
13.
Function Menu: to hide/show it via mouse-clicking ; each side-bar icon matches
corresponding function, please refer to Home of Function Menu for details -