User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
１４
dot-tick "I accept the above 2 License Agreement(s)", again "Next",
dot-tick "I accept the above 2 License Agreement(s)", to continue "Next".
Another "Next", based upon the step done, last "Next", eventually, press "Restart" until PC restarts,
the full NI-VISA driver will be installed successfully.
iii. to run PC Software
Via short-cut to PC software from PC desktop, double-click “VDS6000 Series PC DSO” to start the
software.