User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
１１
V. How to Communicate Device with PC
i. to install PC Software
firstly, to get the software CD from accessories;
secondly, to run .exe file from software CD on target PC;
thirdly, to wait the PC software successfully installed onto target PC
Note: The PC software for OWON product also available from Lilliput official website www.owon.com.cn
ii. to install NI-VISA driver
to run PC software normally, and smoothly, NI-VISA driver is a must.
Note: On condition that NI-VISA driver, or similar VISA driver already been well-installed onto the target
PC, step ii could be skipped.
i). To download the installer via
http://download.ni.com/support/softlib/visa/NI-VISA/16.0/Windows/NIVISA1600full.exe
ii). Based upon installer fully downloaded, to use mouse double-click it, to press "OK" to get access to
the following window,
via "Browse" to choose the preferred folder, to click "Unzip" until full files unzipped.
Press "OK", to start NI-VISA driver installation.
iii). The following window comes,