User Manual
Table Of Contents
- I.General Safety Requirements
- II.Safety Terms and Signs
- III.PC Configuration Requirements
- IV.Communication Interface Introduction
- V.How to Communicate Device with PC
- VI.Operation Interface of PC Software
- VII.Device Operation
- i.how to set the probe compensation
- ii. how to set the vertical system from PC softwar
- iii. how to set the horizontal system from PC soft
- iv. how to set the trigger system from PC software
- v. how to set channel from PC software
- vi. how to use automatic measurement
- vii. how to set sampling mode
- viii. how to set built-in function generator
- ix. how to use cursor measurement
- x.how to set the display system
- xi.how to change utility setting
- xii.how to use main action button
- xiii.how to use LAN communication interface
- xiv.how to work WiFi with PC software
- VIII.Technical Specifications
- IX. Appendix
６
II. Safety Terms and Signs
Safety Terms
Terms in this user manual. It covers,
Warning It states the condition or the operation that may cause body injury or permanent
life loss.
Caution It states the condition or the operation that may cause device damage, or its
accessory damage, or communicated facility damage.
Terms on the device. It covers,
Danger It means the operation may result in the immediate body injury.
Warning It means the operation may result in potential body injury.
Caution It indicates the operation may result in potential damage to the device, or its
accessory, or communicated facility.
Safety Signs
Signs on the device. It covers,
Hazardous Voltage
please refer to user manual for
further details
Protective Earth Terminal
Chassis Ground
Communication Interface Ground