Instruction Manual

9
CRS-LMIC LAPEL MIC FEATURES - The CRS-LMIC Lapel Microphone is used with the Pendant Mic for
inconspicuous hands-free presentations.
35. MICROPHONE – Detects audible sound such as voice. Should be positioned as close to the speaker’s mouth as
possible.
36. LAPEL CLIP – Attaches the Lapel Microphone to a jacket lapel, shirt or blouse.
37. MINI PLUG - Connects to the MIC Input on the CRS-PMIC Pendant. High output IR LED’s on the Pendant
output audio as infrared pulses in an omni-directional pattern that are received by the CRS-IRS IR Sensors. The
IR Sensors electrical DC pulses to the CRS-301-CASE which converts them back to audio signals, amplifies them
and outputs the audio to the Speakers.
NOTE: When connected, the Lapel Mic overrides the Pendant Microphone, so only the Lapel Mic will be active.
Figure 9. CRS-LMIC Lapel Mic Figure 10. CRS-HSMIC Headset Mic (Optional)
The CRS-HSMIC Lapel Microphone is used with the Pendant Mic and is another option for hands-free
presentations.
NOTE: The CRS-HSMIC is an optional accessory and must be purchased separate from the CRS-301.
38. MICROPHONE – Detects audible sound such as voice. Should be positioned as close to the speaker’s mouth as
possible.
39. MIC BOOM – Adjustable mic boom allows the microphone to be set to the optimum position. The Boom will
extend out from the Headset by carefully pulling the Boom, not the microphone, from the Boom Hinge. The
Boom can also be swiveled into position by carefully turning the Boom at the Boom Hinge. Push the Wire Clips
toward the Boom Hinge to create slack in the wire before adjusting. Try not to flex or strain the wire connection at
the end of the boom more than necessary to avoid damaging the wire.
40. BOOM HINGE – Allows positioning the microphone as described in Item 38 above.
41. EAR CLIPS – Secures the Headset by wrapping the ear clips around the user’s ears.
42. WIRE CLIPS – Secure the Headset Wires to the Headset.
43. MINI PLUG – Connects to the MIC Input on the CRS-PMIC Pendant. High output IR LED’s on the Pendant
output audio as infrared pulses in an omni-directional pattern that are received by the CRS-IRS IR Sensors. The
IR Sensors output DC electrical pulses to the CRS-301-CASE which converts them back to audio signals,
amplifies them and outputs the audio to the Speakers.
NOTE: When connected the Headset Mic overrides the Pendant Microphone, so only the Headset Mic will be active.
NOTE 1: The CRS-HHMIC2 is an optional accessory and must be purchased separate from the CRS-301.
44. Reserved
45. ON LED – One LED illuminates green to indicate that the microphone is ON.
46. ON/OFF SWITCH – Turns the microphone ON/OFF.
47. IR OUTPUT ARRAY – High output IR LED’s output audio as infrared pulses in an omni-directional pattern that
are received by the CRS-IRS IR Sensors.
48. CHARGER CONTACTS – These contacts charge the microphone’s re-chargeable battery when inserted into the
CRS-HHMCS Hand Held Microphone Charger.