Instruction Manual

K1. Gain/level control for K

L. Balanced Line Level output

L1. Gain/level control for L

M. CAT5 output to OWI AMP Speakers only

Speakers

1. Strip approximately ¼” off each lead and twist the ends so there are no loose strands that can

cause shorts. The recommended speaker wire size is 14 to 16 gauge.

2. Connect to the appropriate + and – Speaker Terminal. Maintain polarity from the speaker.

NOTE: Though the CRS has Left and Right Line Inputs, the Speaker Outputs are mono, so BOTH channels

will be output from BOTH speakers.

Line In

1. Connect the left and right line level audio outputs of an audio source to the L and R Inputs on the

CRS-301-CASE using a stereo RCA-RCA patch cable with gold ends.

NOTE: Though the CRS has Left and Right Inputs, the Speaker Outputs are mono, so BOTH channels will

be output from BOTH speakers.

2. Feed the audio patch cable through the Wire Access in the CRS-301-CASE Cabinet to allow

connection with the door closed.

Balanced line input

1. Connect the left and right line level outputs of a TV/Projector or DVD Player using a stereo male

RCA to stereo male ¼” phonoadapter.

NOTE: The TV/DVD Input can be adapted to any line level audio device. Connections may vary by device.

COMP

1. Connect the line level audio output of a Computer (stereo 3.5mm mini jack typical) using a stereo

male 3.5mm mini plug to stereo male ¼” phonoadapter.

NOTE: The COMP Input can be adapted to any line level audio device. Connections may vary by device.

Figure 5. CRS-301-CASE Top Panel Figure 6. CRS-301-CASE Side Panel

CRS-301-CASE TOP PANEL FEATURES - The IR Sensors and Speakers get connected to the Side Panel