Installation Instructions Models AMPIC5 / AMPIC6 (Speaker Combination Models AMP1S51 / AMP1S52 / AMP1S54 AMP1S61 / AMP1S62 / AMP1S64) SELF-AMPLIFIED IN-CEILING SPEAKERS (SINGLE INPUT/SOURCE) Established 1978 OWI Incorporated 17141 Kingsview Ave. Carson CA 90746 USA Tel. 310-515-1900 www.owi-inc.
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
13. Unplug this apparatus during lightning storms or when unused for long periods of time. 14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
Installation Instructions Model AMPIC5 / AMPIC6 (UL Listed) AMPIC5 / AMPIC6 carton includes the following items: 1. One (1) each AMPIC5 or AMPIC6 2. One (1) each UL Listed Power Supply ( IC5/IC6, Tile Bridge, Backcan and Volume Controls are Optional – Sold Separately) Introduction: The AMPIC5/AMPIC6 is designed to provide an OWI 5.25” (IC5) or 6.5” (IC6) speaker that is self powered allowing line input audio that is either balanced or unbalanced to provide the input signal.
OWI SELF-AMPLIFIED (SINGLE INPUT/ SOURCE) SPEAKER MODULE AMPIC5 OR AMPIC6 Description: Having many of the recent most popular installer features, the AMPIC 5/6 power module is made to expressly fit onto the OWI Model IC5 or IC6 coaxial speaker providing a high fidelity module providing up to 25 watts of Class AB power right at the speaker.
Powering secondary speakers without amplifiers in paging only applications For paging applications, voice only, very minimal current is needed therefore 18 gauge in most cases up to 250 ft will be sufficient. Amplifier Protection The amplifier is protected from shorts, over heating and will shut itself down until the heat or short is removed. To avoid heat issues, an extra large heat sink is featured on the amplifier. Loud music installations, dance floors etc. Provide power at every speaker.
Page 7 of 16 Filename:AMPIC5_6 MANUAL 07/18/08
SELF AMPLIFIED SPEAKER TO NON-AMPLIFIED SPEAKERS DETAILED WIRING DIAGRAM Page 8 of 16 Filename:AMPIC5_6 MANUAL 07/18/08
Trouble Shooting Guide 1. 2. 3. 4. 5. No output: Disconnect any secondary speakers and check for operation of the primary speaker only. If still there is no output, check for loose screws on the green input connector. It is easy to think the wires are secured in the connector and one wire is not. Tug on each wire to make sure each is tight. Intermittent output: Check for shorted output causing the amplifier to into and output protection. Check each input wire for loose screws.
OWI INCORPORATED 17141 Kingsview Ave Carson, CA 90746 Date Purchased: _____________________ Model Number: _____________________ Serial Number: _____________________ (Keep this part for your record) -----------CUT AND MAIL-------------------------------------------- OWI INCORPORATED 17141 Kingsview Ave Carson, CA 90746 LIMITED ONE YEAR WARRANTY (Self-Amplified Speaker) Model Number:_______________________________________________ Model Name: ________________________________________________ Serial No.
Page 11 of 16 Filename:AMPIC5_6 MANUAL 07/18/08
Page 12 of 16 Filename:AMPIC5_6 MANUAL 07/18/08
IN-CEILING/WALL-MOUNT SPEAKERS I N S T A L L A T I O N / O W N E R S' M A N U A L MODEL IC5 / IC6 (NON-AMPLIFIED SPEAKERS) SPEAKER SPECIFICATIONS: DESCRIPTION: MODEL IC5 MODEL IC6 5.25" 2-way in-ceiling speaker 6.
location. This location must be free of obstructions, such as electrical conduits, HVAC ducts, or water lines. Be sure the mounting surface is between 3/8 and 1 1/4 inches thick, and there is at least a 2 3/4 inch clearance behind the mounting surface and no wall studs or other objects block the back of the speaker. Remove the round cardboard disc from the template supplied and keep it for later use as a paint mask, if you decide to paint your speakers.
Attach the speaker wires to the speaker terminals. Insert your OWI speaker into the opening and tighten the four screws. As you tighten the screws, the tabs will automatically flip into an outward position thereby clamping the drywall between the feet and the flange of the speaker. BE CAREFUL NOT TO OVER TIGHTEN, OVER TIGHTENING MAY WARP THE BAFFLE, CRACK THE WALL, CAUSE THE FLANGE TO DISTORT AND MAKE THE GRILL DIFFICULT TO INSTALL. Push the grille firmly into the slot in the speaker baffle.
OWI INC. LIMITED FIVE YEAR WARRANTY (IC5/IC6 NON-AMPLIFIED IN-CEILING SPEAKER) 1. Your OWI speakers have been thoroughly tested and inspected at the factory. They are warranted for 5 years from the date of purchase. It is the owner's responsibility to establish the date of purchase by acceptable evidence at the time service is sought. 2.
