Instructions / Assembly

Cut Time—Not Tabs

Starter Shingle Roll from Owens Corning eliminates the

need for cutting shingle tabs or inverting them to create a

starter row. So you save time.

Easy Application

Application is a snap too. Simply apply a single

course of Starter Shingle Roll along a clean, dry

and smooth eave line, after removing the release

sheet. Apply the Starter Shingle Roll directly onto

the WeatherLock

underlayment or a layer of felt.

Once it is pressed into place, you’re ready to begin

shingling.

The Starter Shingle Roll advantages:

• Eliminates time-consuming tab cutting

or shingle flopping

• Comes in handy individual rolls, measuring

7.2" wide x 33'4" long (0.183m x 10.18m)

• Easy peel-and-stick application

• Requires no special tools, hardware or training

• Compatible with most Owens Corning™ shingles, see

back for application instructions

• Meets CCMC 13403–R

Starter Shingle Roll

For use at Eave & Rake

Starter Shingle Roll are a component of the Owens Corning™ Total Protection Roong System.™

PAGE 1
Starter Shingle Roll For use at Eave & Rake Cut Time—Not Tabs The Starter Shingle Roll advantages: Starter Shingle Roll from Owens Corning eliminates the need for cutting shingle tabs or inverting them to create a starter row. So you save time. • Eliminates time-consuming tab cutting or shingle flopping Easy Application Application is a snap too. Simply apply a single course of Starter Shingle Roll along a clean, dry and smooth eave line, after removing the release sheet.
PAGE 2
Starter shingle roll Application instructions Before installing this product, check roofing manufacturer’s application instructions and local building codes for their roofing requirements. 1. Application: Align Starter Shingle Roll with eave & rake edge granular side up with the seal strip closest to the outer edge of the roof. Remove release backer and press to assure full adhesion to the underlayment. For rake application, install drip edge first before applying. See Fig.