Installation Guide
Product Data Sheet
EcoTouch
®
Sound Attenuation Batts
with PureFiber
®
Technolog y
Fire Safety
Sound Attenuation Batts are
considered non-combustible
when tested in accordance with
ASTM E136. They are rated at
10 ame spread and 10 smoke
developed when tested in
accordance with ASTM E84. Wall
assemblies with SAB installed in
the cavities can achieve up to a
2 hour re resistance rating when
tested in accordance with
ASTM E119.
Special
Due to the potential for skin
irritation Sound Attenuation
Batts should not be used in open
cavities that will be subject to
human contact. If specifying for
an open cavity, remember to use
supplemental support for heights
over 8.'
Product should be kept dry during
shipping, storage and installation.
Applicable Standards
Sound Attenuation Batt Insulation
is manufactured in compliance
with ASTM C665 Type I.
Laws regulating the New York
City Materials and Equipment
Acceptance (MEA) Division
have been repealed. Federal
Speci cation HH-I-521F has
been canceled and is replaced by
ASTM C665.
Surface Burning Characteristics/Building Code Construction
Classi cation
1
Products Flame Spread Smoke Developed ICBO BOCA SBCCI ICC
Unfaced 10 10 All Ty pes All Ty pes All Ty pes All Types
1. Sound Attenuation Batt Insulation complies with ICBO (Uniform Building Code), BOCA (National Building Code)
and SBCCI (Standard Building Code) and ICC (International Building Code) model code requirements for building
costruction types listed above. Products are tested in accordance with Surface Burning Characteristics ASTM E84.
Water Absorption
Maximum by Volume Less than 0.05%
Dimensional Stability
Linear Shrinkage Less than 0.1%
Acoustic and Fire Ratings for Typical Steel Stud Partitions
STC Test No. Construction Description
Fire
Test
Fire
Rating
Double Layer Wall System
56 W02184 ½ " Type “X” gypsum; 3
5
⁄8" SS, 3½ " thick, EcoTouch
®
Sound
Attenuation Batt Insulation
WP 1521
†
2 Hr.
54 W03084 ½ " Type “X” gypsum; 2½ " SS, 2 ½ " thick, EcoTouch
®
Sound
Attenuation Batt Insulation
WP 1546 2 Hr.
Unbalanced Wall System (2 layer/1 layer gypsum)
55 W02484 Unbalanced
5
⁄8" Type “X” gypsum; 3
5
⁄8" SS, 3½ " thick, EcoTouch
®
Sound Attenuation Batt Insulation
WP 1052 1 Hr.
52 W02884 Unbalanced
5
⁄8" Type “X” gypsum; 2½ " SS, 2½ " thick, EcoTouch
®
Sound Attenuation Batt Insulation
UL U494 1 Hr.*
Unbalanced with Resilient Channel Wall System
58 RAL-TL90-345
5
⁄8" Type “X” gypsum single layer, resilient channel, one side;
double layer other side; 3
5
⁄8" SS, 3½ " thick, EcoTouch
®
Sound
Attenuation Batt Insulation
UL U465 1 Hr.*
Single Layer Wall System
50 RAL-TL89-157 Single Layer
5
⁄8" Type “X” gypsum; 3
5
⁄8" SS, 3½ " thick, EcoTouch
®
Sound Attenuation Batt Insulation
UL U465 1 Hr.
47 W05182 Single Layer
5
⁄8" Type “X” gypsum; 2½ " SS, 2½ " thick, EcoTouch
®
Sound Attenuation Batt Insulation
UL U494 1 Hr.
Single Layer with Resilient Channel Wall System
54 RAL-TL90-344 Single layer, resilient channel, one side only;
5
⁄8" Type “X” gypsum;
3
5
⁄8" SS, 3½ " thick, EcoTouch
®
Sound Attenuation Batt Insulation
UL U465 1 Hr.*
†Listed in the Gypsum Association “Fire Resistance Design Manual”
Key: SS = Steel Stud
Disclaimer of Liability
Technical information contained herein is furnished
without charge or obligation and is given and accepted
at recipient’s sole risk. Because conditions of use may
vary and are beyond our control, Owens Corning makes
no representation about, and is not responsible or
liable for the accuracy or reliability of data associated
with particular uses of any product described herein.
Nothing contained in this bulletin shall be considered a
recommendation.
The GREENGUARD INDOOR AIR QUALITY
CERTIFIED mark is registered certi cation mark
used under license through the GREENGUARD
Environmental Institute.
OWENS CORNING INSULATING SYSTEMS, LLC
ONE OWENS CORNING PARKWAY
TOLEDO, OHIO 43659
1-800-GET-PINK
®
ww w.owenscorning.com
Pub. No. 18141-S. Printed in U.S.A. January 2012. THE PINK
PANTHER™ & ©1964-2012 Metro-Goldwyn-Mayer Studios Inc. All Rights
Reserved. The color PINK is a registered trademark of Owens Corning.
©2012 Owens Corning.
Formaldehyde
FREE


