Installation Guide

R-30C EcoTouch
®
PINK
®
Fiberglas
™
Insulation for 2x10 Cathedral Ceilings
Product Data Sheet
R-30C EcoTouch
®
Insulation
Unfaced, Kraft faced
Excellent Thermal Control
Owens Corning
™
R-30C
EcoTouch
®
Thermal Batt insulation
is designed to provide maximum
thermal performance for cathedral
ceiling applications. R-30C Thermal
Batt EcoTouch
®
insulation is
available unfaced or with a kraft
vapor retarder.
Long Term In-Place Performance
R-30C EcoTouch
®
Thermal Batt
insulation is dimensionally stable
and will not slump within the
cathedral ceiling cavity. Due to its
inorganic nature, EcoTouch
®
Thermal Batt insulation will not rot
or mildew and is non-corrosive to
steel, copper and aluminum.
Sized for Proper Ventilation
R-30C EcoTouch
®
Thermal Batt
insulation is designed to eliminate
R-value loss caused by compressing
standard R-30 products in 2x10
cathedral ceiling construction. 8¼ ”
thick,
R-30C EcoTouch
®
Thermal Batt
insulation prevents moisture
damage and helps assure long roof
life by providing 1" of ventilation air
space between the insulation and
roof deck.
Easy Installation
R-30C EcoTouch
®
Thermal Batt
insulation is easy to handle and
install. Designed to friction- t in
standard 2x10 cathedral ceiling
construction, R-30C EcoTouch
®
Thermal Batt insulation eliminates
the need, in most applications, for
ventilation baf es. Trimming and
fabrication can be done with an
ordinary utility knife.
Technical Design
Considerations
The kraft facing on this insulation
will burn and must not be left
exposed. Install facing in substantial
contact with the  nish material.
Protect from open  ame or other
heat source.
Cathedral ceiling applications
require that the building envelope
block the movement or air from the
outdoor environment to the
conditioned space. Neither the
insulation nor its facing should be
relied upon to provide an air barrier.
Product Data R-30C EcoTouch
®
Thermal Batt Insulation
Width Length Thickness R-Value
1
Cathedral Ceiling Construction 15½ " (394mm)
23¾ " (603mm)
48" (1,219mm) 8¼ ” (209mm) 30.0
1. The higher the R-value, the greater the insulating power. Ask your Owens Corning representative for the fact sheet
on R-values. C Insulation for cathedral ceiling applications.
Available Vapor Retarder Facings Kraft
Max. by Volume 1
Water Absorption
Max. by Volume Less than 5%
Dimensional Stability
Linear Shrinkage Less than 0.1%
Surface Burning Characteristics/Building Code Construction Classi cations
Products Flame Spread Smoke Developed ICBO BOCAI SBCCI ICC
Unfaced <25 <50 All Types All Types All Types All Types
Kraft-faced N/R N/R III, IV, V 3,4,5 III, V, VI III, IV, V
EcoTouch
®
Thermal batt insulation complies with Uniform Building Code (ICBO), National Building Code (BOCAI),
Standard Building Code (SBCCI), and Iternational Building Code (ICC) model code requirements for building construc-
tion types listed above. The kraft facing on thermal batt insulation will burn and must not be left exposed. Install facing
in substantial contact with the  nish material. Protect from open  ame or other heat source.
9½ ", R-30 EcoTouch
®
Thermal Batt Insulation
Standard Batts compressed into a 9¼ " cavity with
ventilation baf e added to allow 1" air space deliver
approximately R-28.
8¼ ", EcoTouch
®
Thermal Batt Insulation
New R-30C batts provide the recommended ventilation
air space when properly installed and deliver a full R-30.
Read This Before You Buy
What you should know about
R-Values
The chart shows the R-value of this
insulation. R means resistance to
heat  ow. The higher the R-value,
the greater the insulating power.
Compare insulation R-values before
you buy.
There are other factors to consider.
The amount of insulation you need
depends mainly on the climate, the
type and size of your home, and
your fuel use patterns and family
size. If you buy too much insulation,
it will cost you more than you’ll save
on fuel.
To get the marked R-value, it is
essential that this insulation be
installed properly.
®