Data Sheet

STORAGE

XSTRAND™ filaments must be stored in a dry and temperate

location. The product should remain in its original packaging,

preferably closed, until beginning of use.

WARNING

When melted, XSTRAND™ filament can be abrasive due to its glass

reinforcement. Printing with XSTRAND™ may reduce brass nozzles

and extruder driving wheels’ lifetime. For a better experience, using

hardened steel nozzles and extruder driving wheels is advised.

Ensure sufficient ventilation in your 3D printing space and avoid

inhaling extrusion fumes.

CONTACT

For any questions related to XSTRAND™ 3D products, contact us at:

3dprinting@owenscorning.com

Material Safety Data Sheet available upon request.

Revision date: January 22

, 2018

This information and data contained herein is offered solely as a guide in the selection of

reinforcement. Rating contained in this publication is based on actual laboratory data, field test

experience and observation of overall market use. We believe this information to be reliable, but do

not guarantee its applicability to the user’s process or assume any responsibility or liability arising out

of its use or performance. The user agrees to be responsible for thoroughly testing any application to

determine its suitability before committing to production. It is important for the user to determine the

properties of its own commercial compounds when using this or any other reinforcement. Because of

numerous factors affecting results, we make no warranty of any kind, express or implied, including

those of merchantability and fitness for a particular purpose. Statements in this publication shall not be

construed as representations or warranties or as inducements to infringe any patent or violate any law

safety code or insurance regulation. Owens Corning reserves the right to modify this document without

GF30-PA6 Technical datasheet Rev2 January 2018

PAGE 1
STORAGE XSTRAND™ filaments must be stored in a dry and temperate location. The product should remain in its original packaging, preferably closed, until beginning of use. WARNING When melted, XSTRAND™ filament can be abrasive due to its glass reinforcement. Printing with XSTRAND™ may reduce brass nozzles and extruder driving wheels’ lifetime. For a better experience, using hardened steel nozzles and extruder driving wheels is advised.
PAGE 2
MATERIAL DATASHEET Physical Properties Metric Imperial 1,17 g/cm3 Density Standard 9,76 lbs/gal ISO 1183-A Moisture Absorption 0,58 % 0,58 % ISO 62 23 °C / 50% RH Water Absorption 9,62 % 9,62 % ISO 62 23 °C / Sat Mechanical Properties Tensile Modulus Metric Imperial 7 400 MPa Standard 1,074 ksi ISO 527 1 mm/min (0.04 inch/min) 14,800 psi ISO 527 1 mm/min (0.04 inch/min) 102 MPa 14,800 psi ISO 527 1 mm/min (0.04 inch/min) 2.1 % 2.1 % ISO 527 1 mm/min (0.