Data Sheet

STORAGE

XSTRAND™ filaments must be stored in a dry and temperate

location. The product should remain in its original packaging,

preferably closed, until beginning of use.

WARNING

When melted, XSTRAND™ filament can be abrasive due to its glass

reinforcement. Printing with XSTRAND™ may reduce brass nozzles

and extruder driving wheels’ lifetime. For a better experience, using

hardened steel nozzles and extruder driving wheels is advised.

Ensure sufficient ventilation in your 3D printing space and avoid

inhaling extrusion fumes.

CONTACT

For any questions related to XSTRAND™ 3D products, contact us at:

3dprinting@owenscorning.com

Material Safety Data Sheet available upon request.

This information and data contained herein is offered solely as a guide in the selection of

reinforcement. The information contained in this publication is based on actual laboratory data and

field test experience. We believe this information to be reliable, but do not guarantee its applicability

to the user’s process or assume any responsibility or liability arising out of its use or performance. The

user agrees to be responsible for thoroughly testing any application to determine its suitability before

committing to production. It is important for the user to determine the properties of its own

commercial compounds when using this or any other reinforcement. Because of numerous factors

affecting results, we make no warranty of any kind, express or implied, including those of

merchantability and fitness for a particular purpose. Statements in this publication shall not be

construed as representations or warranties or as inducements to infringe any patent or violate any

law, safety code or insurance regulation. Owens Corning reserves the right to modify this document

Revision date: December 8

, 2017

PAGE 1
STORAGE XSTRAND™ filaments must be stored in a dry and temperate location. The product should remain in its original packaging, preferably closed, until beginning of use. WARNING When melted, XSTRAND™ filament can be abrasive due to its glass reinforcement. Printing with XSTRAND™ may reduce brass nozzles and extruder driving wheels’ lifetime. For a better experience, using hardened steel nozzles and extruder driving wheels is advised.
PAGE 2
MATERIAL DATASHEET Physical Properties Metric Imperial 0,94 g/cm3 Density Standard 7,85 lbs/gal ISO 1183-A Moisture Absorption Very low (<0.1%) Very low (<0.1%) ISO 62 23 °C / 50% RH Water Absorption Very low (<0.1%) Very low (<0.1%) ISO 62 23 °C / Sat Mechanical Properties Metric Imperial Standard 6 500 MPa 943 ksi ISO 527 1 mm/min (0.04 inch/min) 60 MPa 8,700 psi ISO 527 1 mm/min (0.04 inch/min) 60 MPa 8,700 psi ISO 527 1 mm/min (0.04 inch/min) 1.6 % 1.