Installation manual

2 Disassembly
Using the Torx T8 screwdriver, remove the 3 2mm hex head (the Torx
is the same size as a 2mm or 5/64 hex bit) screws that are used to hold
the bottom cover onto the Mac mini. Do not exert too much force, Torx
drivers are not as strong and can strip if you are not careful.
Also remove the 2 Torx T8 screws opposite the Airport antenna. These
secure the bottom hard drive in place.
Gently lift up on the Airport
antenna cover from the side closest
to the logic board.
Pivot the Airport antenna cover
gently towards you and to the right.
The Airport antenna is attached to
the Airport card still. The antena
connection is under a hinged black
plastic cover - gently lift it to expose
the antenna connection. Lift on
the connetor body itself to remove
from the Mac mini.
Use caution - it is fragile.
⑪
⑩
⑨⑧
Mac mini 2011-2012 2nd Hard Drive Kit