Installation manual

4 Assembly
Using the Torx T8 screwdriver, insert the 3 2mm hex head (the Torx is
the same size as a 2mm or 5/64 hex bit) screws that are used to hold the
bottom cover onto the Mac mini. Again use caution when inserting, Torx
screws are not as strong, do not overtighten.
Insert the 2 Torx T8 screws opposite the Airport antenna. These secure
the bottom hard drive in place.
While making sure to keep the
black Airport cable pointed so it
naturally will lay back under the
chassis, slide the Airport Antenna
cover into the chassis. The edge of
the cover will slip into a channel cut
out for it in the chassis.
Make sure it is straight.
Pivot the Airport antenna cover
gently into the Mac mini as shown.
Turn the black Airport cable so that
the silver connector loops around
from the inside top and attach the
connector onto the Airport card.
The connector snaps straight down
onto the card.
Use caution - it is fragile.
⑭
⑮
⑰⑯
Mac mini 2011-2012 2nd Hard Drive Kit