Specifications

Here you see the OWC Mercury On-The-Go Pro drive inserted into the
acrylic enclosure, ready to have it’s end cap attached.
Insert the acrylic endcap, fully sliding it over the bridge card ports.
Once you have the endcap on, attach it to the enclosure using the 2
included small Phillips screws. The location is circled above.
Do not exert too much force while screwing these in, you can acciden-
tally strip the screw head easily.
OWC Mercury On-The-Go Pro Chapter 2 - System Setup
2 SYSTEM SETUP
2.1 Hard Drive Assembly & Installation (continued)