Specifications

OWC Mercury On-The-Go Pro Chapter 2 - System Setup
2 SYSTEM SETUP
2.1 Hard Drive Assembly & Installation (continued)
Slide the bridge card with the hard drive into the aluminum heatsink -
there is a notch that the bridge card will slide into.
Secure the hard drive using 4 screws from the included plastic bag,
through the heatsink, into the hard drive. Don’t overtighten, start all 4
screws before fully tightening.
Gently slide the completed heatsink, drive, and bridge assembly into
the acrylic enclosure. Take 4 Phillips screws from the included plastic
bag and once again, don’t fully tighten the screws, just start them,
as you will need to rock the assembly back and forth a bit to get all 4
screws started, then you can tighten them. Note that there is a rubber
mounting strip on the bottom of the heatsink, that makes it a bit di-
cult to get the screws all the way in. You may nd holding the enclosure
in your hand, screws down, works best.