User Manual

OWC MERCURY ON-THE-GO PRO DEVICE SETUP
5
4. Align the front edge of the circuit board (i.e. the edge opposite the power switch)
with the two grooves on the heat sink (below left). Once aligned, carefully slide
the entire circuit board into the enclosure, until the board contacts the front cover
(below right).
5. Take the plastic end-cap and align its cutouts with the ports on the circuit board
(below left); make sure the end-cap is not upside down. Next insert the end-cap
into the back of the enclosure. The cutouts in the end-cap should sit ush around
the data port(s) and the power switch should protrude through the corresponding
cutout (below right).