User Manual

OWC MERCURY ON-THE-GO PRO DEVICE SETUP

2.1 Quick Start

NOTE: If you are installing your own 2.5 inch SATA drive, skip this section and

proceed to Section 2.2 for assembly instructions.

You will need to format the Mercury On-The-Go Pro before using it. The OWC Drive

Guide formatting utility has been pre-installed to assist you. Follow the steps below

to use Drive Guide to format the Mercury On-The-Go Pro for Mac (OS X 10.4 and

later) or Windows (XP and later). Connect the drive to the computer using the proper

cable. If you prefer to use a dierent formatting utility, do so at this time, then skip

ahead to Section 3.1 to review additional support information.

1. The drive will show up as “OWC SETUP”. Open the drive to view its contents.

2. Double-click the OWC Drive Guide application.

3. Follow the on-screen instructions to complete the formatting process.

4. Once the formatting is nished the drive is ready to use.

2.2 Assembly Steps

1. Remove the small piece of protective foam from the open end of the enclosure.

Tilt the enclosure slightly so that the blue circuit board slides out enough that you

can remove it from the enclosure.

DEVICE SETUP