User Manual

OWC MERCURY ELITE PRO MINI
DEVICE SETUP
7
7. Using a Phillips screwdriver, insert the four included screws into the screw holes to
fasten the drive to the inner chassis (shown below). When this is done, turn the inner
chassis back over.
8. Slide the inner chassis back into the outer enclosure. Note
that the inner chassis can slide in either end of the outer
enclosure, but the rails on one end of the outer chassis are
notched, as shown to the left. This allows the back plate to
sit flush when attached.
9. Using a Phillips screwdriver, attach the back plate as shown to complete the assembly.