User Manual

OWC MERCURY ELITE PRO MINI
DEVICE SETUP
5
2. Tilt the Mercury Elite Pro mini up at the front to allow the back plate to fall free, as
shown below. If the back plate does not immediately fall free, you can push gently on
the on/off switch to disengage the ports from the back plate and allow it to come off.
3. Gently push on the inner chassis that was
exposed by removing the back plate. The
inner chassis should slide out of the outer
enclosure. Once there is enough room at the
front, as shown to the left, you can pull on the
front of the inner chassis to remove it fully.
4. Once the inner chassis has been removed
from the outer enclosure (shown below), note
the SATA connector (arrow). There are also
four screw holes (circled in red): two through
the metal on the right and two through the
green circuit board on the left.