User Manual

Mercury Elite Pro mini Device Setup

1. Use a Phillips PH2 driver to remove the two screws at the rear of the

enclosure (circled below in red).

2. Tilt the Mercury Elite Pro mini to allow the back plate to fall free, as

shown below. If the back plate does not fall free, you can push gently

on the ON|OFF switch to disengage the ports from the back plate.

3. Gently push on the inner chassis

that was exposed by removing the

back plate. The inner chassis should

slide out of the outer enclosure.

Once there is enough room at the

front, as shown to the left, you can

pull on the front of the inner chassis

to remove it fully.