Manual

OWC MERCURY ELITE PRO DUAL
DEVICE SETUP
7
6. Using eight of the larger screws from the packet you removed from the inner chassis,
fasten the inner chassis to the hard drives. There are four screw holes on each side of the
inner chassis, circled below in red.
7. Slide the inner chassis back into the outer enclosure. Note that while the inner chassis can
slide into both sides of the outer enclosure, there is only one correct way that will allow
the screw holes to line up correctly.
To determine the correct orientation of the outer enclosure with the inner chassis, turn
the outer enclosure on its side and look at the bottom. As shown below, the screw holes
at the front of the outer enclosure are close to the silicone feet. The screw holes at the rear
of the outer enclosure are farther away from the silicone feet.
REAR FRONT