Manual

OWC MERCURY ELITE PRO DUAL
DEVICE SETUP
6
4. Install the first hard drive (Drive 1), as shown below. Slide the SATA connector on the hard
drive into the black SATA connector (circled in red). Make sure the drive is firmly seated in the
black SATA connector before proceeding. NOTE: In this picture, the red SATA cable used to
connect the second hard drive has been removed. This was done to provide a better image
of the drive installation only. Do not remove any cabling from the Elite Pro Dual.
5. Install the second hard drive (Drive 2), as shown below. Insert the SATA connector from
the red cable into the SATA connector on the hard drive. Make sure the SATA connectors
are seated firmly before continuing. NOTE: Make sure that the flat red cable is twisted as
shown (below-right) in order to avoid interfering with the exhaust fan.