Manual

OWC MERCURY ELITE PRO DUAL
DEVICE SETUP
8
8. Once you have determined the correct orientation, slide the inner chassis back into the
outer enclosure, as shown below.
9. Once the front grill of the inner chassis sits flush with the edge of the outer enclosure, turn
the Elite Pro Dual on its side again to look at the screw holes on the bottom. You should
see that the screw holes in the outer enclosure line up with the screw holes in the inner
chassis. Use the four smaller screws to fasten the inner chassis to the outer enclosure, as
shown below. The assembly of the Elite Pro Dual is now complete.