Operation Manual

5V
500
mAh
4.2 ± 0.03V
Battery usage and charge duration reference
Battery type
Battery
specification
Single charge
working time
Charging time
Rechargeable lithium
-
polymer battery (Li
-Poly)
3.7 V 350
mAh
Drone flight time: up to
10 minutes
About 90 minutes (charging
current approx.
0.5 A)
Zinc
-carbon battery
(Non rechargeable)
1.5V
(GP 15G
R4P)
Controller (transmitter)
operation time: 18
hours
Non rechargeable (do not
charge)
5. TRANSMITTER AND RECEIVER SYNCHRONIZATION
Step 1
Turn on the drone using the switch located on the back by moving it to "ON" position. Place the drone on a
flat surface to ensure the gyroscope is centered.
Do not move the drone during the synchronization process.
Step 2
Switch the controller's power but
ton to "ON" position. The LED indicator starts to blink. Wait 5 seconds until
the synchronization process starts.
Push the throttle stick from the lowest to the highest position, and then push it back to the lowest position.
When the LED indicator stops bl
inking and starts to glow steadily, and the controller emits a beep sound, it
means that the synchronization process is finished.
Step 3
After the flight, move the controller's switch to "OFF" position (the power LED is off). Then, power off the
drone
using the same method - move the power switch located on the back of the drone to "OFF" position.
The lights will go off indicating that all the systems are off.
6. FLIGHT CONTROL
Mode
Mode
Fly forward / backward
Throttle stick
Ascent / descent,
Rotate left / right
Left / right
Direction / rotation
control stick
Left
Right
360-degree stunts
After pressing the Flip button, move the direction stick forward, backward, left or right to flip the drone in the
chosen direction.
Speed modes
The device supports three flight speed modes. Press the flight speed button to switch between fast, medium
and slow mode. The number of beeps and the speed of blinking of the controller's LED indicate a currently
chosen mode.