Operation Manual

[MD]motion detection recording

[Alarm]alarm recording

7.2.3 PTZ setting

User can set PTZ channel, protocol, address, baudrate etc. Please make sure the PTZ address and connection is

correct between PTZ’s A, B wire and recorder’s A, B wire.

[Channel]select a channel with PTZ camera

[Protocol]select PTZ camera’s PTZ protocol(such as: PELCOD)

[Address]set address, the default is

（

Note

：

this

address must be the same with PTZ, otherwise the PTZ can

not be controlled）

[Baudrate]Select the baud rate. Default is 9600.

[Data Bits]default: 8

[Stop Bits]default: 1

[Parity]default: None

[DVR control]click to enable

[Frequency]default: 3seconds, users can set any digits between 1~30 seconds

7.2.4 Alarm

Video detect

[Main menu]-[Alarm]-[Detect], shows below: