Operation Manual

6 Basic Operations Guide
6.1 Power On and Off
6.1.1 Power On
Install the DVR/NVR correctly (as above) and then connect the power. The DVR/NVR LED should light up and
the DVR/NVR will boot automatically.
The DVR/NVR will then automatically detect any connected hardware (cameras, monitors, etc.), this process
should last about 30 Seconds. When this process has been completed the DVR/NVR will enter the multi-screen
real-time surveillance mode.
If your hard drive is not properly connected, the following message will appear on your screen.
kit.
Note：Please do not use any type of power supply which is different from the power supply included in this
6.1.2 Power Off (Shutdown)
Right mouse click →[Main Menu]→[Shutdown]
Note: Only change or attempt to reconnect the hard disk drive after shutting down the DVR/NVR.
6.1.3 Restart
Right mouse click →[Main Menu]→[Shutdown]→[Restart system]