Installation Instructions

Helmet Indicator Light

Model: Blinxi

Work mode

TX press two keys for 60s at the same time to enter the test mode.

After entering the test, the left and right indicator lights are

always on. There are six modes. Press left and right to switch.

The power is attenuated. Then press two keys for 5 seconds to

exit the test and enter the code matching mode

RX long press the key 60s to enter the test mode, and the

indicator light also has an indication. Short press this key to

switch 6 modes, and long press 5 seconds to exit the test mode

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

Changes or modifications to this unit not expressly approved by

the party responsible for compliance could void the user’s

authority to operate the equipment.

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

PAGE 1
Helmet Indicator Light Model: Blinxi Work mode TX press two keys for 60s at the same time to enter the test mode. After entering the test, the left and right indicator lights are always on. There are six modes. Press left and right to switch. The power is attenuated. Then press two keys for 5 seconds to exit the test and enter the code matching mode RX long press the key 60s to enter the test mode, and the indicator light also has an indication.
PAGE 2
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver.