Warranty

Unplug the Grill from the wall outlet and allow it to cool
completely.
Wipe the Cooking Plates with a sponge or cloth
dampened in warm soapy water.
Always dry plates thoroughly after cleaning. To remove
stubborn stains or food, use a nylon brush or other
utensil safe for nonstick surfaces.
Do not use steel wool or scouring pads. Do not use
abrasive cleansers.
Wipe the exterior with a clean, damp cloth. Dry all parts
thoroughly before using again or storing.
DO NOT USE ABRASIVES OR METAL UTENSILS.
DO NOT IMMERSE GRILL HOUSING IN WATER OR ANY
OTHER LIQUID.
PANINI GRILL CARE & MAINTENANCE
9
ovente.com
ELECTRICAL REQUIREMENTS
Voltage : 120V
Power: 1000W
Hertz: 60Hz
Your Panini Maker is best used with thick, crusty breads,
such as French, Italian, and focaccia. You can grill a Panini to
perfection in about 3 minutes (depending on the bread,
filling, and personal taste). Your Panini Maker can also be
used to grill a variety of food items, such as meats,
poultry, fish, and vegetables.
Warning: Always ensure that your Drip Cup is in place before
using your Panini Press. Never use your Panini Maker
without your Drip Cup in place
Preheat the grill. Your grill will not properly preheat unless
the grill is in the closed position.
Close the cover and plug into a 120-volt 60 HZ AC outlet only.
The red light will turn on indicating that the appliance is
preheating, and the green light will illuminate when the
appliance is preheated and ready for use.
Open the lid being careful not to touch any hot surfaces
such as the housing or grill plates. We recommend the use
of oven mitts or potholders to prevent the risk of injury.
Place items to be cooked on the bottom grill plate.
BEFORE FIRST USE
Carefully unpack your Panini Grill. Remove all packaging
materials.
Place the device on a flat, level surface close to a 120 volt
wall outlet.
Wipe off both Cooking Plates with a damp cloth so that they
are clean and free of any manufacturing oils that may be left
on the surface.
Wipe the outside of the Grill Housing with a soft damp cloth.
NEVER immerse the grill, power cord and plug in water or
any other liquid.
Plug into the wall outlet and heat for 5 minutes. This will burn
off any residue from the manufacturing process.
NOTE: There may be a small amount of smoke or
odor during this time but it will not last longer than a
few minutes.