OVE SMART TOILET Model EBBA INSTRUCTION MANUAL Measures: inch [millimeter] 25-1/2” [650] 16-1/2” [420] 2” -1/ 31 00] [8 5-15/16” [150] 12” [300] 22-5/8” [575] 15-3/4” [400] 25-1/2” [650] 2-ø5/8” [2-ø16] ø3-1/16” [ø78] 12-1/8” [380] Thank you for choosing OVE SMART TOILET. Please read and understand this entire manual before attempting to assemble, operate or install this product. p.
CONTENT SAFETY NOTICE ............................................................................................. p.3 WARNINGS ...................................................................................................... p.4 PART LIST ........................................................................................................ p.5 INSTALLATION INSTRUCTIONS ................................................................. p.6-8 BATTERY INSTALLATION .....................................
SAFETY NOTICE ATTENTION! BEFORE INSTALLING THE PRODUCT, YOU MUST READ AND UNDERSTAND CAREFULLY ALL BELOW WARNINGS. 1. It is forbidden to disassemble toilet by yourself. 2. Please do not set this product in a wet place, because it is an electronic product. If set in the bathroom, please insure that there is proper air flow. 3. Please insure that the product is set more than 0.6 meter away from the bathtub. 4. Please make sure electric power is AC 120V.
WARNING Do not leave the toilet exposed to the sun. May cause yellowing or color fading. To prevent against power surge damages, make sure the ground is working in the power socket. Direct sunlight affects the good functioning of the remote. Radio or transmitting devices may interfere with the toilet’s remote control functions If you do not plan to use the toilet for a long time, close the inlet water valve and unplug the toilet.
PART LIST M L A J B I K H C F D E G N Item Qty A Remote Receiver 1 B Control keypad 1 C Water filter (preinstalled) 1 D Water inlet valve (not supplied) 1 E Supply line 1 F Nozzle 1 G Seal ring 1 H Drying air outlet 1 I Seat 1 J Light indicator panel 1 K Remote 1 L Ball valve 1 M Check valve 1 N Side holes covers 2 p.
INSTALLATION INSTRUCTIONS 2 5-15/16” [150] 1 12 ” [3 4” -3/ 05 ] 0] [40 NOT SUPPLIED 15 Ensure that your water inlet pipe and your floor discharge drain are installed according to the drawing. These are minimum measurements, the toilet can be installed if your actual measurements are longer than shown. TIP: Align 2 pieces of masking tape with the center of the drain, this will help you position the toilet in future steps. 3 Position correctly the two fixing bolts of the floor flange.
INSTALLATION INSTRUCTIONS 8 Using a wrench, install the washer and the nuts of the flange bolts through the toilet’s side holes. Tightly screw the nut to secure the toilet. 9 With care, re-install the seat on the ceramic base and connect the electrical plug at the back of the toilet. Then cover the side holes with the supplied covers. 10 NOT SUPPLIED Snap Ring Pull out the snap ring from the connector. Firmly push the bidet water tank tube protruding behind the toilet inside the pressure connector.
INSTALLATION INSTRUCTIONS 13 Ensure that the ball valve at the back of the toilet is open. Open the water inlet valve and check for leaks. 14 24h Apply silicone around the base of the toilet. Wait for 24h for it to dry. p.
BATTERY INSTALLATION BATTERY USAGE SAFETY GUIDELINES 1. Always purchase the correct size and grade of battery most suitable for the intended use. 2. Clean the battery contacts and also those of the device prior to battery installation. 3. Remove batteries from equipment which is not to be used for an extended period of time. 4. Remove batteries if consumed or if product is to be left unused for a long time. 15 2x 1.5V AAA Battery (NOT INLCUDED) Load the remote with two AAA batteries.
FIRST TIME USE 1 Open the water supply inlet valve. 2 Plug the toilet in the power socket. 3 The toilet’s blue light will start blinking. The blinking light indicates that the wash tank is filling with water, a sensor in the toilet will stop the filling process automatically after around 3 minutes when the tank is full of water. After the wash tank is filled with water, the indicator light will stop blinking. 4 The toilet will turn ON automatically.
CONTROLS DESCRIPTION STOP: Pressing this button will stop any ongoing function. POWER: Press 1 time, it will turn the toilet ON. Press 2 times, it will turn the toilet OFF. DRY: Pressing this button will initiate the warm air drying. BIDET/MOVE: Pressing this button will initiate the Static Bidet Cleaning function. Press it again to change to the Back-&-Forth Bidet Cleaning function. *The Bidet refers the 5 water jets function of the nozzle.
CONTROLS DESCRIPTION STOP: Pressing this button will stop any ongoing function. Pressing this button during the setting mode will quit the setting. SPRAY/MOVE: Pressing this button will initiate the Static Spray Cleaning function. Press it again to change to the Back-&-Forth Spray Cleaning function. *The SPRAY refers to the 1 water jet function of the nozzle. BIDET/MOVE: Pressing this button will initiate the Static Bidet Cleaning function.
CONTROLS DESCRIPTION ● All the settings from last usage are kept in memory for the next use. The remote control display will turn off automatically. To wake it up, press any button 1 time.
FEATURES SPRAY CLEANING (1 WATER JET) This function will only work if the user is sitting on the toilet. Press the SPRAY/MOVE button for spray cleaning. Water will spray and clean the user. Press the button again and the nozzle will move back & forth to ensure the cleanest result. You can use this key stroke to get the best cleaning effect. BIDET CLEANING (5 JETS OF WATER) This function will only work if the user is sitting on the toilet. Press the BIDET/MOVE button for bidet cleaning.
INTELLIGENT FEATURES ECO MODE ECO MODE will cut down the electricity usage of your smart toilet during times of none-usage. The cleaning water tank will start heating the water only once the user is sitting on the toilet, whereas in normal mode, the cleaning water is kept to your preferences for your instant enjoyment. SOFT CLOSE DESIGN The toilet seat and seat cover have a soundless soft close design that prevents them from falling rapidly and denting or scratching the toilet.
CHANGING THE FILTER 1 Close water inlet valve on your wall, and the ball valve at the back of the toilet. Unscrew the supply line and the 7/8” adaptor at the back of the toilet. 2 The water filter is located inside the 7/8” adaptor. Gently remove it and gently brush it with a toothbrush to remove any residue. Place the filter back inside the adaptor. 3 Reconnect the 7/8” adaptor and the water supply line to the toilet’s water inlet. Open the ball vavle at the back of the toilet.
LONG TERM STORAGE In order to prevent any damages that may be caused from frozen toilet water, please drain away the remaining water according to the following methods. When leaving for a long time without using this toilet, please make sure to drain all the water from the toilet. 1. Close water inlet valve. 2. Unfasten the nut with a Allen key and remove the water drain bolt. 3. After draining all the water, please tightly screw the water drain bolt back into place. 4.
SPECIFICATION SHEET Item Electric Load Electric Cord Content AC 120V / 1140W / 60HZ 1.2 m insulated power cord Cleaning System Spray Cleaning (1 jet) Bidet Cleaning (5 jets) Water Temp Heater Capacity Cleaning Tank Capacity Overheating Safety Anti-Reflux Water amount adjustment 0.4-1.0 L/min (water pressure 0.19 MPa / 27.6 psi) Water amount adjustment 0.5-1.0 L/min (water pressure 0.19 MPa / 27.
OVE LIMITED Product Warranty – United States Only OVE is a distributor of the following Product: OVE Smart Toilet Ebba Warranty Period: 2 years from date of sale to first retail purchaser.
INSTALLATION PICTURE p.
Save this manual for future reference Conservez ce manuel pour usage ultérieur Conserve este manual para futura referencia HEAD OFFICE / SIÈGE SOCIAL / OFICINA PRINCIPAL 2800 Etienne Lenoir, Laval Quebec H7R 0A3 Canada Customer service / Service à la clientèle / Service al cliente Tel.: 1-866-839-2888 Fax: 1-866-922-9990 8:00 am - 5:00 pm E.S.
