Installation Guide

10
1. Insertthexedpanel’sbottomsealstrip(I)atthebaseofthexedglasspanel(A),40mmfromthepanel’sedge.
2. Insertthexedglasspanel(A)intothemetaltrack(B).
3. Slidetheslidingdoorguide(E)ontothebottomofthexedglasspanel(A),butdonotsecure.Ensuretheplastic
gasketintheguideisinplaceasthisprotectsthexedglasspanel.
Note: The wall track (B) allows you to adjust the position of the xed glass panel (A). Adjusting the depth and/
or giving the xed glass panel a slight angle allows for precise alignment with the door.
4-5. Mark the positions of holes of the sliding door guide (E) with a pencil, and drill pilot holes with a ø3mm (1/8in) drill
bit. Then secure sliding door guide (E) with screws (BB) and add the decorative caps (KK).
6-7. Oncealladjustmentshavebeenmade,drillthexedpanel(A)withΦ3mm(1/8in)in3places,securethewall
track(B)usingscrews(AA),ttingsandcaps(FF).
8. Slide the 2 stoppers (M) and the 2 support bar’s anchors (N) onto the support bar (D).
9. Looselymountthesupportbar(D)ontoxedglasspanel(A)usingthebrackets(II)andlevelit.
10. Mark the outline of the 2 support bar’s anchors (N).
FIXED PANEL INSTALLATION
1 2
3
A
FF
I
A
B
AA
A
E
KK
M
N
D
II
D
A
N
8
9
10
A
Φ3mm
1/8in
7
Φ3mm
1/8in
BB
E
Helpful Hint
Add a drop of
silicone in the
holes before
inserting the
screws
5
6
4