Installation Guide

1. Slide the 2 stoppers (E) and the 2 support bar’s anchors (D) onto the support bar (F).

2. Looselymountthesupportbar(F)ontoxedglasspanel(C)usingthebrackets(G)andlevelit.

3. Mark the outline of the 2 support bar’s anchors (D) on the wall.

4-6. Completely remove the support bar. Place the 2 support bar’s anchors (D) back on their wall mark, then mark

their center on the wall.

Note: Before continuing, place the door panel (J) inside the shower enclosure to facilitate future steps!

7. Drill a hole on the center marks and insert the wall anchors (AA) using a rubber mallet.

8.Fixthecenterttingofthesupportbar’sanchors(D)usingthescrews(GG).

9Slideagaintherollerstoppers(E)andthesupportbar’sanchors(D)ontothesupportbar(F).Thenxthesupport

bar to the wall.

10.Fixthexedpanel(C)ontothesupportbar(F)usingthebrackets(G).

11. Securethesupportbar(F)ontheiranchorsusingtheprovidedhexscrews.Installthealuminumprole(V)

between the roller stopper and support bar’s anchors.

SUPPORT BAR INSTALLATION

Φ8mm

5/16in