Installation Guide

10
1-2. Insertthexedpanel’sbottomsealstrip(N)atthebaseofthexedglasspanel(C).Cutthesurpluspartwitha
cutter to size, about 40mm from the panel’s edge.
3. Place the sliding door guide (Q) on the base.
4. Mark the positions of holes of the sliding door guide (Q) with a pencil, and drill pilot holes with a ø4mm (3/16in) drill
bit.
5. Fix the sliding door guide (Q) with the screw (CC). Ensure the plastic gasket in the guide is in place as it protects
thexedglasspanel.
6-7. Placethexedglasspanel(C)intothewalltrack(B)andtheslidingdoorguide(Q).
Note: The wall track (B) allows you to adjust the position of the xed glass panel (C). Adjusting the depth and/
or giving the xed glass panel a slight angle allows for precise alignment with the door.
8. Drillthexedpanel(C)withΦ3mm(1/8in)in3places.
9. Securethewalltrack(B)usingscrews(DD),ttings(FF)andcaps(EE).
FIXED PANEL INSTALLATION
40mm
N
N
C
2
760mm
30mm
703mm
Q
3
Φ4mm
3/16in
4
CC
5
6
EE
DD
FF
9
1
Q
B
C
C
N
Q
7
C
N
Helpful Hint
Add a drop of
silicone in the
holes before
inserting the
screws
150mm
8
Φ3mm
1/8in