Operation Manual

The Outpost Log System
73
Normally when you open this window you will see your network address, but if you
selected the Configuration Wizard during the Outpost Firewall installation process and
removed all detected networks, then this window will most likely be blank. To detect your
network automatically, click the Detect button.
It is also recommended that you keep Auto-detect new network settings selected for
Outpost Firewall to automatically detect any new networks so you will not have to add
them manually.
If you wish to allow all connections for a particular network, select the corresponding
check box in the Trusted column. Otherwise, if you want to remove the network address
from the Trusted Zone, clear the check box.
If you want to allow all NetBIOS communications—to and from a network address—make
sure the corresponding box in the NetBIOS column is selected. To disallow all
communications with the network, just clear the NetBIOS and Trusted check boxes.
You can also add a custom remote network address to Trusted Zone. Click the Add button
to display the following dialog window: