User's Manual

Table Of Contents

Updating the Home

Page 10

Step 1. Power o the riser.

Step 2. Insert the USB into the correct USB port (depending where the

Home is installed.)

Step 3. Press and hold the reset button on Home or Joplin. For the Home,

the button is on the back side. It is the only button on Home.

Step 4. Power on the riser and in about 10 seconds the 2x white LEDs turn

on. The LEDs are located on the top on both devices.

Step 5. Release the reset button once the 2x LEDs are ON. After a few

seconds 4x white the LED’s turn on. After a few more seconds, all LEDs go

blank. The ﬂashing is in process.

Step 6. Once the ﬂashing is ﬁnished, one of the following two things will

happen:

1. If ﬂashing is successful, all LEDs glow green. If ﬂashing fails, all LEDs

glow red. If this happens, retry the process.

2. If still red LEDs show, then there is an issue with the software on the

USB. Reboot the riser with the newly ﬂashed sofware, by powering o then

back on.

Setting the Default Volume on the Joplin and

Home

Page 11

Note: There are 11 volume levels, the default is set at 6. The default volume cannot

be set lower than 6 but can be set higher than 6.

Step 1. Make an “M” gesture on the screen to access the Joplin and Home volume

controls.

Step 2. Adjust the volume to desired levels using the volume controls that appear

after the “M” gesture is made.

Step 3. To set the desired defualt volume for the Home and Joplin after adjusting

the volume to the desired level, hold the mute button located on the back of the

home for a few seconds or use the Reset button on the joplin.